一、 操作步驟
1、
可采用一般室溫條件，但實驗需在無風的條件下進行。
2、
將已裝好試樣的試樣夾置于試樣架上。
3、
將準備好的棉線掛在掛鉤上，將標志線穿過試樣夾平板的導絲鉤，生產紡織品阻燃可燃性測試儀，然后在剛穿出導絲圈的標志線下方掛一重錘，紡織品阻燃性測試儀，使之繃緊。
4、
打開控制面板上的“電源開關”，顯示初始界面。
﹨s
按顯示屏上的向下鍵
，進入試驗界面。
﹨s
(c)
brushing device. h (1) this device cists of a baseboard
over which a smaller carriage is drawn. this carriage on parallel tracks
attached to the edges of the upper surface of the baseboard. the brush is
hinged with pin hinges at the rear edge of the baseboard&rests on the
carriage vertically with a pressure of 150 grams.
h see §1610.61(c)(2) for a clarification of the brushing technique for
fabric with raised-fiber surfaces.
c 刷毛裝置。h1該裝置由一個底板組成，可燃性，底板上有一個較小的托架。該車廂在與底板上表面邊緣相連的平行軌道上運行。電刷與底板后緣的銷鉸鏈鉸接，垂直放置在托架上，銷售紡織品可燃性測試儀，壓力為150克。
h見§1610.61c2，了解纖維表面凸起織物的刷洗技術。
(2)
the brush cists of two rows of stiff nylon bristles mounted with the tufts
in a staggered ition. the bristles are 0.016 inch in diameter&0.75 inch
in length. there are 20 bristles per tuft&4 tufts per inch. a clamp is
attached to the forward edge of the movable carriage to permit holding the
specimen on the carriage during the brushing operation.
刷毛裝置
2 刷子由兩排剛性尼龍刷毛組成，刷毛交錯安裝。刷毛直徑為0.016英寸，長度為0.75英寸。每簇有20根鬃毛，每英寸有4根。夾具固定在可移動托架的前邊緣，以便在刷牙操作期間將試樣固定在托架上。
登錄后臺
