1、
記錄燃燒時間,然后按控制面板上的“復位”鍵,銷售紡織品可燃性測試儀,使儀器恢復到初始狀態,為下次試驗做準備。
2、
剩余試樣分別按照步驟1-10進行試驗。
所有試驗完成后,關閉瓶罐上方連接器氣閥。關閉儀器電源,清理接渣盤,使燃燒箱內干凈整潔。
3、
本儀器符合《gb/t 14644-2014 紡織品 燃燒性能 45o方向燃燒速率的測定》與《cfr 1610-standard for the flammability of clothing textiles》兩標準。如按照cfr 1610進行試驗,只需將點火器進行更換即可。
(2)
specimen rack (b, fig. 2). the specimen rack provides supports for the
frames in which the specimens are mounted. the angle of inclination is 45°. two
guide pins projecting downward from the cct of the base of the rack travel
in slots provided in the floor of the chamber so that adjustment can be made
for the thickness of the specimen in relation to the flame front. a stop is
provided in the base of the chamber to assist in adjusting the ition of the
rack.
2 樣本架b,圖2。樣品架為安裝樣品的框架提供支撐。傾角為45°。從機架底座中心向下-的兩個導銷在燃燒室地板上的槽中移動,可燃性,以便調整試樣相對于火焰的厚度。腔室底部設有止動塊,以幫助調整齒條的位置。
(15)
stopw-h&timing mechanism (n, fig. 2). this w-h, by means of
spe-l attachments, is actuated to a start by connection with the gas jet (e,
fig. 2). a driving mechanism on rear of cabinet ( s, fig. 2) moves the
gas jet to its most forward ition&automatically starts the timing at the
moment of flame impact. the falling weight (h, fig. 2), when caused to move by
severance of cord (f, fig. 2), s the w-h. timing is read directly.
15 秒表和計-構n,供應紡織品阻燃可燃性測試儀,圖2。該表通過特殊附件,生產紡織品可燃性測試儀,通過與氣體噴射器e,圖2的連接啟動。機柜后部的驅動機構s,圖2將氣體射流移動到其前面的位置,并在火焰沖擊時自動開始計時。落錘,圖2因繩索f,圖2的分離而移動時,使手表停止轉動。計時是直接讀取的。